ADVANCED Codecs inurl.php password#

To workaround this known problem you must open the 'Advanced Options' dialog. The hardphone will take g711a as the one-and-only selected codec and starts sending g711a.ĮyeBeam will playback g711a without any problem while sending g711u, but the hardphone CANNOT playback g711u. If eyeBeam is called from a hardphone that offers 'g711a,g711u,g729,g723'ĮyeBeam will send an answer with 'g711a,g711u', but starts sending g711u. In opposite to most embedded VoIP devices ('hardphones'), eyeBeam does support switching between different codecs without re-negotiation and even different audio codecs in send and recv direction.Įmbedded VoIP devices on the other hand require same audio codec in send and recv direction (symmetric codec) and change of codec requires re-negotiation using another SDP offer/answer exchange. EyeBeam subscribes for 'message-summary' and gets notifications in case of any state change.ĮyeBeam softphone supports a lot of different audio codecs.

EyeBeam softphone supports 'Message Waiting Indication'.

EyeBeam softphone can do a conference with two or more remote parties.

Music on hold is heard on the eyeBeam softphone during transfer.

EyeBeam softphone can be transferred to another remote party.

EyeBeam softphone can initiate blind transfer.

EyeBeam softphone receives music on hold provided by the PBX.

EyeBeam softphone can be held/retrieved by remote party.

The held party gets music on hold from the PBX.

EyeBeam softphone can put an established call on hold and retrieve it.Even special characters (ä,ö,ü) are rendered correctly.

EyeBeam softphone shows the remote partys display name.EyeBeam softphone can be called from other PBX users.EyeBeam softphone can call to other PBX users.See 'Known Problems' for details (very important to avoid one-way audio). Usually the voice mail number of a PBX user is constructed by appending the phone number of the PBX user to the voice mail prefix ('4' + '217'). To make eyeBeam interrogate for current voicemail status, enable 'Check for voice mail' and enter the voice mail number of the eyeBeam user: +x.T match=1 prestrip=1 pre=000 will remove the `+´ from an international number and replace it with 000 (assuming this is your international trunk prefix from an internal line). You can use the Dialing plan to support international numbers, e.g. Open 'Properties' of a new account and fill like this: On the eyeBeam softphone go to 'SIP Account Settings. config/video.Connecting eyeBeam with innovaphone PBX using SIP protocol.įollow instructions provided with eyeBeam. config/sensor.cgi?flicker=50&sharpness=40Ĭhange codec of profile 1 to MJPEG stream and back to H264 config/user_mod.cgi?name=UserName&password=XXXX&group=UsersĬontrast, brightness, saturation, flip, mirror, etc. I could create a new user in the group Users but only with a blank password.

ADVANCED Codecs inurl.php password#

However, it is not possible then to use that password to log in. The command changes the admin’s password successfully. config/wireless.cgi?essid=Name&passphrase=PasswordĪdd/delete user or group, change password config/network.cgi?httpport=XXXX&httpexternalport=YYYY Vprofileurl1=/video/ACVS-H264.cgi?profileid=1 Run CGI-URL without parameters to obtain a list of available parameters and their values. NIPCA-API details and more CGI-URL possibly compatible with DCS-8000LH are e.g. NIPCA-API (Network IP Camera Application Programming Interface)